NETWORK SETUP
|
Item |
Setting |
Default setting |
Description |
|---|---|---|---|
|
TCP/IP |
ENABLE DISABLE |
ENABLE |
Sets whether to enable or disable TCP/IP. |
|
NETBIOS OVER TCP |
ENABLE DISABLE |
ENABLE |
Sets whether to enable or disable NETBIOS OVER TCP. |
|
IP ADDRESS SET |
AUTO MANUAL |
AUTO |
Sets the method of assigning an IP address. |
|
IPV4 ADDRESS |
xxx.xxx.xxx.xxx |
If a cable is connected 169.254.XXX.XXX If a cable is not connected 192.168.100.100 |
Sets an IP address. |
|
SUBNET MASK |
xxx.xxx.xxx.xxx |
Sets a subnet mask. |
|
|
GATEWAY ADDRESS |
xxx.xxx.xxx.xxx |
Sets a gateway (default router) address. 0.0.0.0 means no router. |
|
|
WEB |
ENABLE DISABLE |
ENABLE |
Sets whether to enable or disable WEB. |
|
TELNET |
ENABLE DISABLE |
DISABLE |
Sets whether to enable or disable TELNET. |
|
FTP |
ENABLE DISABLE |
DISABLE |
Sets whether to enable or disable FTP. |
|
IPSEC |
ENABLE DISABLE |
DISABLE |
This item is displayed and it can be disabled only when IPSec is set to valid. |
|
SNMP |
ENABLE DISABLE |
ENABLE |
Sets whether enable or disable SNMP. |
|
NETWORK SCALE |
NORMAL SMALL |
NORMAL |
[NORMAL]: The printer operates effectively even if connected to a HUB with the spanning tree function. However, the printer takes longer to start up if it is connected to a small LAN that consists of two or three computers. [SMALL]: This setting covers a small LAN that consists of two or three computers to a large LAN, but the printer may not operate efficiently if it is connected to a HUB with the spanning tree function. |
|
GIGABIT NETWORK |
ENABLE DISABLE |
DISABLE |
Sets giga-bit network support. |
|
HUB LINK SETTING |
AUTO NEGOTIATE 100BASE-TX FULL 100BASE-TX HALF 10BASE-T FULL 10BASE-T HALF |
AUTO NEGOTIATE |
Sets the hub linking method. Normally, select [AUTO NEGOTIATE]. |
|
FACTORY DEFAULTS |
EXECUTE |
Sets whether to initialize the network menu. |