Setting the Printer

This section describes how to set the printer to use DHCP.

The DHCP protocol is enabled by factory default, and you do not need to perform this procedure.

Memo

The following procedure uses Network Card Setup as an example. The descriptions in this manual may vary depending on your software.

  1. Insert the "Software DVD-ROM" into a computer.

  2. When [AutoPlay] is displayed, click [Run Setup.exe].

  3. Select a language from the drop-down list.

  4. Read the license agreement, and then click [Agree].

  5. Read the "Environmental advice for Users" thoroughly, and click [Next].

  6. Select [Network(Wired/Wireless)], and click [Next].

  7. Select the printer to be set, and click [Network Setting].

  8. Select [Auto], and click [Setup].

  9. Input the network password of the printer, and click [OK].

    The factory default network password is the last six digits of the printer's MAC address.

    The settings will be saved in the printer, and the network functions will be restarted.