Setting the Printer

To enable IPSec, you must set the printer by using the Web page in advance.

Note

  • If IPSec is set to the printer and the host, IPSec communication is established. If IPSec is not set to the host, IPSec communication is not established.

  • Take notes of the values specified in this procedure not to forget these values. These values are necessary when setting IPSec on a computer.

  1. Open the Web page of the printer.

  2. Log in as the administrator.

    How to log in as the administrator

    About the Web Page of the Printer

  3. Select [Admin Setup].

  4. Select [Network Setup] > [Security] > [IPSec].

  5. Follow the on-screen instructions to set detailed settings.

    Memo

    You must enable either [AH] or [ESP] in the "Phase2 Proposal" setting.

  6. Click [Submit].

    The new settings take effect when the network function of the printer restarts.

Note

If you were unable to set up IPSec due to the inconsistency of the parameters that were specified, you cannot access the Web page. In such a case, disable the IPSec from the operator panel of the printer or initialize the network settings.